3 Fig. S1. Samples collected at each step during ramping of acetone flow rate in water-toluene-acetone system, where a) is for a one PTFE membrane system and b) is for a system containing both a PTFE and a glass microfiber membrane. Yellow arrows indicate
high flow and retention, compared to existing filter technologies. Description High flow, high retention, hydrophobic PTFE membrane in a low-extractables, high density polyethylene (HDPE) cartridge Improve Performance with GORE® Filters Advanced Membrane
PTFE hydrophobicity. No loss in flow rate. Plus, optimized Sartofluor cartridge con-struction allows differential pressures up to 0.5 bar at 134 C. This exceptional per-formance has been confirmed by Bacterial Challenge testing.
High Air Flow Rate Venting Applications Offers broad chemical compatibility with PTFE membrane and polypropylene housing 100% integrity-tested to provide the high level of confidence you require 2 Part numbers available
.jpg)
Membrane filter AISIMO provides a wide selection of membrane materials for the microfiltration with different pore sizes Typical applications for membrane filters are cell retention, particle collection, clarification and sterile filtration of aqueous solutions, particulate analysis, microbiological analysis and epifluorescence microscopy.
Flow rate range The typical flow rates used in the bubble trap are between 0 to 2mL/min, but up to 6ml/min can be achieved if few bubbles are present in the liquid. Up to 60ml/min can be achieved for the high-flow trap when a vacuum line on the dry side of the
A single-layer PTFE membrane construction ensures validated sterility, while providing maximum flow rate over a wide range of operating conditions. The optimal performance-to-cost ratio allows benefiting from the lowest cost-of-ownership for air/gas and aggressive solvent filtration.
PTFE membrane filters are strong and resistant to acids, bases, and solvents, and stable at high temperatures. With their low background and low tare mass they are ideal for gravimetric or aerosol/gas/vapour sampling. They are also available in preloaded, leak-free
25/2/2021 · GasPro ™ TEM-2260 series filters are specifically designed for the filtration of semiconductor gases when ultra-high flow rates are required. This all-welded assembly will deliver 0.003 micron particle retention where a high flow rate is required and space is limited. A PTFE membrane and polypropylene supported cartridge is enclosed in a 316L
POLIFLO PTFE cartridge are manufactured using a highly hydro-phobic Gore ePTFE membrane. The enhanced ePTFE membrane offers exceptionally high gas flow rates at low pressure differentials (see graph). POLIFLO PTFE cartridges are recommended for
MS ® high flow filtration systems enable high-flow filtration in high-pressure vessels to provide ideal protection of reverse osmosis membranes. MS ® 600 FlowPure-HF cartridge filter is designed in innovative technology to achieve flow rate up to 450gpm per 40inch element. It can provide absolute efficiency for consistent product quality and multi
It guarantees high flow rate and filtration speed. Material They are made from PTFE (polytetrafluoroethylene) and they are compatible with any syringes. The pore size for these products is 0.45 um. Area of Use It can remove some larger bacteria such as Serratia
Wetted Parts. To ensure maximum corrosion resistance, purity levels and low particle generatation, Yamada pumps feature diaphragms, liquid chambers and manifolds that are machined from 100% virgin PTFE. Polypropylene and High Density Polyethylene are used in the air motor section (non-wetted) to ensure resistance in a corrosive environment.
