Advantec membranes are produced by three different processes. Mixed Cellulose Ester and Cellulose Acetate are reverse phase solvent cast membranes, where controlled evaporation or removal of the complex solvent system forms the porous structure.
Advantec membranes are produced by three different processes. Mixed Cellulose Ester and Cellulose Acetate are reverse phase solvent cast membranes, where controlled evaporation or removal of the complex solvent system forms the porous structure.
PTFE Membrane Filters. Biopore Membrane Filter roll, Hydrophilic PTFE This Biopore membrane roll is hydrophilic, with a pore size of 0.4 microns. Milliseal Membrane Seal, PTFE, 18 mm This is a 18 mm Hydrophobic PTFE Membrane Filter with a 0.45 micron pore size. For use in Sterilizing filtration, bioassays, solvent filtration.
Nylon PES PTFE PVDF ACIDS Acetic, 5% L R R R R Acetic, 10% L R R R R Acetic, 25% N L R R R Acetic, Glacial N N R R R Boric - L - R - Formic 25% L N - R - Hydrochloric 15% L L R R L Hydrochloric 25% N N R R - Hydrochloric concentrated N N L R N
2018/8/7 · A versatile cellulose-based hydrophilic membrane that is resistant to a very large range of solvents, including aqueous solutions and organic solvents. Recommended for use in HPLC and protein recovery applications. DO USE: with most common solvents
You do solvent filtration if your process stream contains more than 10 wt% solvent. Above this level, the solvent may attack your membrane material. This can lead to a change in retention or even to a total dissolution of your membrane. Depending on your solvent and your process conditions this can happen sooner or later.
2010/1/18 · ・ADVANTEC is launching new membranes for Lateral Flow Assays based on Immunochromatographic method. Perfectly suitable for Lateral flow assays based on Immunochromatographic methods is the nitrocellulose membrane which actively traps proteins. Five product lines are available with five types of absorbing speed.
It is recommended to verify conditions before use. ● PTFE membrane is hydrophobic and not for use with liquids with a surface tension ≥ 32mN. Prewetting the membrane with isopropyl alcohol or ethyl alcohol will allow filtration of aqueous solutions.
Hydrophilic PTFE Membrane is a thin, unsupported porous film which is treated to be hydrophilic. This membrane exhibits high flow Hydrophobic PTFE Supported (J-type) Membranes. PTFE membrane is manufactured in a unique way where polytetrafluorethylene (PTFE) is expanded both uniaxially and biaxially.
商 品 說 明 資 料. Hydrophobic PTFE Membrane (TCF) • Enhanced chemical resistance. • Selected types can be in-line steam sterilized (126°C, 30 min) or autoclaved (121°C, 30 min) APPLICATIONS. • Filtration of photo resists and organic solvents. • Uses in the electronics industry and in chemical manufacturing. • Filtering gases and venting tanks.
The enhanced PTFE membrane offers exceptionally high liquid flow rates at low pressure differentials making Fluorofil™ F100 cartridges ideally suited to solvent filtration. For solvent and aggressive chemical filtration applications, Fluorofil™ F100 cartridges offer a wide range of chemical compatibility with high thermal stability.
DESCRIPTION. Membrane Solution’s advanced PTFE membranes (pore size:0.03-5μm) achieve the perfect combination of high flow rate,high retention and cost-effective. Material characteristics of MS®PTFE membrane include small diffusion flow and more pores in any given area. MS®PTFE membrane for filtration including hydrophobic membrane and hydrophilic
