As one of the leading global innovators of filtration solutions, Cobetter focuses on membrane technology application and R&D. In addition, we are dedicated
high efficiency and excellent flow rates. Using a combination of glass-reinforced polypropylene, polypropylene and polyester hardware and support materials,
or vent filter are air flow rate and particulate/microorganism High. AcroPak 300 Capsule with PTFE Membrane ... 0.2 µm. Effective Filtration Area.
(µm). Special Features. Syringe Filters. Some. 4, 15, 25,. RC, PES, SFCA,. 0.2, 0.45,. Ideal for small volume pressure. 26, 28. NY, PTFE. 0.8 (SFCA only).
We offer different membrane filters with pore sizes from 0.2 μm – 8 μm for particle removal or High flow rates in air pollution monitoring and exhaust.
Regardless of the membrane filter material, always use a 0.2 µm pore size Rapid-Flow™ filters is the first choice for sterile filtration of culture ...
Specifications. 50 mm Vent Filter. Filter Media. Hydrophobic PTFE reinforced with polypropylene. Pore Size [µm]. 0.22 or 0.45. Housing. Polypropylene.
This PP Pleated Micron Filter Cartridges made from high quality material in providing higher flow rates as well as dirt holding capacity while at the ...
Thank you for your interest in, and use of, Global Filter products. If 99.98%) retention efficiencies. Flow Rate. 0.2. 0.45. 1.0 + 2.0 + 5.0.
This membrane exhibits high flow rates with minimal Related Products: Hydrophilic Membrane Filter. Compare this item
Results 1 - 10 of 27 Choice of 13 mm or 25 mm syringe filter diameter to suit sample volume. Choice of 0.2 μm or 0.45 μm pore sizes for retaining a variety of ...
Sartorius Minisart™ NY Syringe Filter, Sterile is ideal for rapid small volume filtration. These ready-to-use units offer high flow rates at low inlet pressures
which permit high throughput and flow rates. Whatman Glass microfiber air filter ... Housing: Polypropylene. Filter media: PTFE. Pore size: 0.2 µm.
Glass Fiber Filters . membranes (typically 150 μm) with high porosity (about ... Flow Rate indicates initial flow rate at 10 psi using a KGS 47 filter.
Omnipore™ PTFE. Hydrophilic. JVWP. 0.1. 0.1. 0.4. 342.3. NA. JGWP. 0.2 1 Water flow rates were measured through 9.6 cm2 of membrane, using 500 mL of ...